Yes, the Flex-a-lite Transmission Cooler # FLX400117 does include the 3/8" hose and clamps that you see in the picture.
Product Contents:
1-17 Row Plate Cooler
1-Section of 3/8" Transmission Hose
4-Hose Clamps
2-Threaded 3/8" Barbed Fittings
4-Foam Pads
4-Plate Cooler Anchors view full answer...
Yes, all the correct fittings and hoses are included. The transmission lines on your 2006 Toyota 4Runner have 3/8inch fittings and the fitting provided in the Derale Series 8000 Plate-Fin Transmission Cooler, item # D13504, will fit on the return side (out) transmission line of your radiator. You will then attach the supplied hose to this fitting and run it to the transmission cooler. Then attach the remaining hose to the other side of transmission cooler and to the return transmission... view full answer...
The Derale oil cooler # D15405 comes with 10 feet of 1/2 inch hose. You could add another 10 feet using # D15700. Then you would just need a 1/2 inch line to 1/2 inch line hose barb fitting from an auto parts store and some additional hose clamps # D13008.
For transmission cooler # D13503 there are no special fittings required for installation. But if the included Insta-dapt fitting does not fit your external transmission cooler and the stock lines are metal you would need to cut and flare... view full answer...
Typically instructions are not included with the Derale Transmission Pan Coolers. I have contacted Derale requesting this information as well but my contact did explain that they do not have any additional instructions that I can send to you.
My contact at Derale did explain that the tubes in the pan area of this cooler are designed to be at the same height and position of a standard OEM pan cooler. Please be aware that if you do currently have a deep pan cooler it is possible that your... view full answer...
The hose that comes with the # D13502 and # D13503 transmission coolers is 4 ft long. This is the same with all Derale 8000 Series transmission coolers.
If you need additional hose length, we offer a 4 ft long individual hose, # D13003, and a 25 ft hose, # D13007. You may also need additional hose clamps, # D13008, if you purchase additional hoses. view full answer...
The Derale transmission cooler # D13502 comes with 4 feet of hose. This is typically enough for most applications but for your 2013 Toyota Tacoma it will likely not be enough. Additional hose is recommended. For an additional 4 foot length of hose use # D13003. For the proper size clamps use # D13008. view full answer...
So the reason the part # D15660 is the most expensive is because it comes with everything needed to install as a engine oil cooler kit since it has multiple fittings as well as the sandwich adapter. This is basically the complete kit.
Next up is the # D15960 which setup to be a transmission cooler and comes with the fittings needed for this application which is considerably less than as an engine oil cooler.
Finally the # D15860 comes with minimal fittings and adapters and would require... view full answer...
The Derale Temperature Gauge Kit, # D13009, comes with a mounting bracket and mounting hardware, a drain plug for transmission pan applications, and a temperature sensor. It has wiring leads in the back for the light inside but not to connect to the 3 terminal in the back.
You can use wire # 10-1-1 which is sold by the foot. Enter the amount of feet you will need in the quantity box. You will need enough wire to reach from the gauge to a 12 volt switched ignition source, a suitable ground... view full answer...
Go To Results